Filter
Top Products
Development System Reference Guide www.xilinx.com 153
Halting MAP
R
MULT_ANDs = 0
4 input LUTs used as Route-Thrus = 0
4 input LUTs = 54
Slice Latches not driven by LUTs = 0
Slice Latches = 0
Slice Flip Flops not driven by LUTs = 3
Slice Flip Flops = 17
Slices = 29
Number of LUT signals with 4 loads = 4
Number of LUT signals with 3 loads = 0
Number of LUT signals with 2 loads = 4
Number of LUT signals with 1 load = 44
NGM Average fanout of LUT = 1.52
NGM Maximum fanout of LUT = 9
NGM Average fanin for LUT = 3.4444
Number of LUT symbols = 54
Halting MAP
To halt MAP, enter Ctrl+C (on a workstation) or Ctrl+Break (on a PC). On a workstation,
make sure that when you enter Ctrl+C the active window is the window from which you
invoked the mapper. The operation in progress is halted. Some files may be left when the
mapper is halted (for example, a MAP report file or a physical constraints file), but these
files may be discarded since they represent an incomplete operation.