Filter
Top Products
Development System Reference Guide www.xilinx.com 339
Dedicated Global Signals in Back-Annotation Simulation
R
Global Signals in Verilog Netlist
For Verilog, the glbl module is used to model the default behavior of global the GSR and
GTS. The glbl.GSR and glbl.GTS can be directly referenced as global GSR/GST signals
anywhere in a design or in any library cells.
NetGen writes out the glbl module definition in the output Verilog netlist. For a non-
hierarchical design or a single-file hierarchical design, this glbl module definition is
written at the bottom of the netlist. For a single-file hierarchical design, the glbl module is
defined inside the top-most module. For a multi-file hierarchical design (-mhf option),
NetGen writes out glbl.v as a hierarchical module.
If the GSR and GTS are brought out to the top-level design as ports using the -gp and -tp
options, the top-most module has the following connectivity:
glbl.GSR = GSR_PORT
glbl.GTS = GTS_PORT
The GSR_PORT and GTS_PORT are ports on the top-level module created with the -gp and
-tp options. If a STARTUP block is used in the design, the STARTUP block is translated to
buffers that preserve the intended connectivity of the user-controlled signals to the global
GSR and GTS (glbl.GSR and glbl.GTS).
When there is a STARTUP block in the design, the STARTUP block hierarchical level is
always preserved in the output netlist. The output of STARTUP is connected to the global
GSR/GTS signals (glbl.GSR and glbl.GTS).
For all hierarchical designs, the glbl module must be compiled and referenced along with
the design. For information on setting the GSR and GTS for FPGAs, see the “Simulating
Verilog” section in the Synthesis and Simulation Design Guide.
Global Signals in VHDL Netlist
Global signals for VHDL netlists are GSR and GTS, which are declared in the library
package Simprim_Vcomponents.vhd. The GSR and GTS can be directly referenced
anywhere in a design or in any library cells.
The X_ROC and X_TOC components in the VHDL library model the default behavior of
the GSR and GTS. If the -gp and -tp options are not used, NetGen instantiates X_ROC and
X_TOC in the output netlist. Each design has only one instance of X_ROC and X_TOC. For
hierarchical designs, X_ROC and X_TOC are instantiated in the top-most module netlist.
X_ROC and X_TOC are instantiated as shown below:
X_ROC (O => GSR);
X_TOC (O => GTS);.
If the GSR and GTS are brought out to the top-level design using the -gp and -tp options,
There will be no X_ROC or X_TOC instantiation in the design netlist. Instead, the top-most
module has the following connectivity:
GSR<= GSR_PORT
GTS<= GTS_PORT
The GSR_PORT and GTS_PORT are ports on the top-level module created with the -gp and
-tp options.